Thank you for your inquiry. Our chat service hours are Monday - Friday from 8 a.m. - 8 p.m. EST. Saturday from 8 a.m. - 4:30 p.m. EST.

If you are trying within the service hours and are still seeing this message, please try again after some time.

Fill or Sensing Light On

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Possible Solutions

SENSING/FILL Light is on

When the Start/Stop button is pressed and the Water Level knob is set to Auto Sensing, the washer will fill and begin sensing to determine load size and balance. Once sensing is complete, the washer will fill to the appropriate level for the detected load size and start the cycle's wash phase.

NOTE: If the fill light is on and there is no or little water coming in, check your water supply lines. For the washer to operate correctly, both water lines should be completely open (turned on).

NOTE: Opening the unlocked lid will pause the Sensing and wash phases. Close the lid to resume the cycle. If the lid is left open for over 10 minutes, the washer will cancel the cycle and pump out the water. The lid will lock after the wash phase to begin the initial spinout and remain closed for the remainder of the cycle.