Thank you for your inquiry. Our chat service hours are Monday - Friday from 8 a.m. - 8 p.m. EST. Saturday from 8 a.m. - 4:30 p.m. EST.

If you are trying within the service hours and are still seeing this message, please try again after some time.

Low Ice Production - Top Freezer Refrigerator

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Possible Solutions

Perform an Ice Cube Test

To determine if the ice maker is making the correct amount of ice, a cube count test can be performed.

Cube Count Test

Empty the ice bin
Wait 24 hours (do not use and/or dispense any ice during this time)
Remove the ice bin and count the ice cubes

This type of ice maker should produce 56 - 72 cubes, during normal operating conditions. If the cube count test results are within the normal range, the ice maker works correctly.

New Installation?

Wait 24 hours after ice maker installation for ice production to begin. Wait three days for full ice production.

Does the water filter need to be replaced?

It is recommended that the Maytag water filter be replaced every 6 months, when the indicator light comes on, or as needed. Replacing your water filter regularly helps to ensure a continual supply of cleaner, fresh-tasting drinking water. Depending on your usage and water quality, it may need to be changed more frequently. A clogged or incorrectly installed water filter can reduce the water flow to the ice maker and dispenser, potentially causing low ice production and a slowed water flow. Maytag recommends using everydrop® water filters. Find the right replacement filter for your refrigerator, and make the simple switch for clean water year-round.

Take a look at Does the Water Filter Need to be Replaced?

Was the water filter flushed?

Flushing the system is needed every time the filter is changed or when it is first installed. Flushing your refrigerator water filter is a key step that reduces excess air, prepares the filter for use, and removes excess carbon. Air in the water system may cause dripping at the dispenser, small or hollow ice cubes, or a cloudy appearance in the water quality. The amount of water needed to flush the water filter varies depending on the specific filter. Some filters require 1, 2, or 4 gallons to be dispensed for a proper flush; refer to the water filter's instructions for specific guidelines.

Review How to Flush the Water System in a Refrigerator for more information.

Was the water line installed correctly?

The refrigerator must be installed to a cold water supply for the ice maker and water dispenser to work. To connect the shutoff valve and the refrigerator, use 1/4" (6.35 mm) O.D. (outside diameter) soft copper or PEX tubing. It is recommended to leave a coil of copper or PEX tubing (service loop) to allow the refrigerator to be pulled out of the cabinet or away from the wall for service or routine cleaning. Water supply lines can be purchased at Maytag Purchase Genuine Parts.

Check to make sure there are no kinks in the water supply line. A kink can reduce water flow. Straighten the water source line to restore adequate water flow and pressure. To help reduce the chances of a pinched water line, do not push the refrigerator too far back against the wall or cabinet.