Using the Load & Go™ Cartridge (some models)

Use only HE High-Efficiency liquid detergents. The dispenser cartridge will hold about 18.5 oz. (550 ml) of HE liquid detergent, or enough for up to 36 loads.

To Fill: Push back on the tab and lift the fill door. Fill to the “Max” line with HE liquid detergent. Close fill door. It will click into place.

To Install the Dispenser Cartridge: 1. Pull out the dispenser drawer. 2. Insert the dispenser cartridge completely in the detergent compartment as shown. It should click into position. 3. Slowly slide the dispenser drawer in until it is completely closed. The washer will automatically detect the dispenser cartridge.

NOTE:  The dispenser cartridge should be rinsed out when changing detergents or when the washer will not be used for extended periods. For instructions on cleaning the dispenser cartridge, see your Owner's Manual.

Disable Load & Go™

To disable the Load & Go™ system and use only a single dose of HE detergent, press the Load & Go™ button until the light turns off. Pour measured amount of liquid HE detergent into the single dose detergent dispenser. The detergent will dispense at the optimum time during the wash cycle.

If using powdered detergent, or single dose detergent packets, place that detergent in the wash basket before starting the load. 

Always use only High Efficiency (HE) detergent.

CLICK HERE for more information about using HE detergent

See your Owner's Manual for information on your specific model.