New installation or electrical connection?

If this appliance was newly installed, check the following to ensure the power supply was connected correctly:

• Strain relief is tightened against the power supply cord.
• All terminal wires are in the correct locations (colors match).
• Hex nuts on the terminal block posts are secure and tightened.
• Check the installation instruction for complete details. 

Is the oven control set correctly?

Refer to your Owner's Manual for more information.

Has there been a recent power outage?

During a power outage, if there was an unexpected amount of power supply line "noise" that the control detected as incorrect voltage amount, the control could display the F9 or F9 E0 error code.  Also, if any keys were pressed before the 10-second delay interval on power-up, this could cause the F9 or F9 E0 to appear.

If a recent power outage has occurred, turn off the household circuit breaker for the range for one (1) minute.  Then reset the circuit breaker and monitor the range for one (1) minute to ensure the error code does not display again.  Verify range operation is normal.

Is the control panel locked or in demo mode (on some models)?

Some ovens may be equipped with a control lock feature. Look for "Control Lock" on the oven control console and then reset by typically holding the button(s) for 3 seconds.

Some ovens may also be equipped with a demo mode feature. When demo mode is enabled, the oven will not operate and the control will display a short presentation highlighting the features of the range.

Refer to the Owner's Manual to learn more about enabling and disabling the demo mode feature. 

Is the control set for a Delay Start? 

The oven can be set for a bake function with a Delayed Start, meaning the bake function will not start until reaching the start time.

Cancel the control and re-start a bake function.